This lovely 50s Gibson had its bridge planed down at some point by someone trying to avoid a neck reset. This is such a mistake! The contour lines at the bridge wings were also rounded over, when this was done, and the saddle-slot became too shallow to properly hold the saddle!
The bridge was still tall enough to use, and being the original part, it was vital to save it.
I filled the slot with a piece of rosewood, then shaped and contoured it into place. While I was at it, I redefined the contours at the wings a bit, too. Moving on to the milling machine, I re-slotted the bridge deeper, to correctly hold the new saddle I'll be making. Next, it will get glued back on this lovely old Gibson.
Thanks for stopping by!